Filter
Top Products
87
(3) Fully open the locking tabs of the communication unit and remove the watch.
* When using the communication unit to charge the watch for the first time, the Install Wizard of
the USB driver is displayed on the personal computer display when the communication unit is
connected to the personal computer. Refer to “3. Installing the USB Driver” for information on
installing the USB driver.
* When attaching or removing the watch to or from the communication unit, make sure to fully
open the locking tab of the communication unit. Attempting to attach or remove the watch
without the locking tab fully open can cause the connection pins to become worn resulting in
poor connection.
* If the metal band of your watch is too short so that the watch cannot be attached to the
communication unit, remove the communication unit leg (removable) and fit the watch onto the
communication unit by passing it over the location where the stand was removed to attach it to
the communication unit.
3. Installing the USB Driver
In the case of performing data communication with a personal computer using the
communication unit, a USB driver must be installed in the personal computer to be used in
advance. Install the USB driver from the CD-ROM provided with the watch by following
the procedure described below. The procedure differs slightly depending on the
compatible OS.
* The display screens used in this explanation differ depending on the language and version of the
OS.
Windows98 or Windows98 SE:
(1) Confirm that your personal computer has started up normally.
(2) End any applications that are currently running on the PC.
(3) Place the CD-ROM provided in the CD-ROM drive of the PC. If the AQUALAND GRAPH
Nx installation menu is displayed at this time, click on the "EXIT" button to close this menu.
(4) If the communication unit is connected to
the USB port of the PC, a message is
displayed on the PC indicating that new
hardware has been detected and that the
PC is searching for the required application
software.
Once this check of new hardware is
completed, the "Add New Hardware
Wizard" is displayed.