Filter
Top Products
3
Before Using
Please make sure to adequately charge the
watch using the charger provided.
This watch is rechargeable.
In addition, the watch display has been turned off prior to shipment from the factory
in order to reduce power consumption by the energy storage cell of the watch.
* Remove the display seal affixed to the watch display before using the watch.
Before using, fully charge the watch by following the procedure described below.
The display can then be illuminated by performing the all-reset procedure.
* Refer to the section entitled, “Charger”, for details on the procedure for installing the 4 pcs.
of size AA alkaline batteries and the procedure for charging the watch.
(1) Install 4 pcs. of size AA alkaline batteries in
the charger provided.
(2) Place the watch in the charger and
charge the watch until the LED on
top of the charger goes out. (It
takes about 7 hours to fully charge
the watch.)
(3) When the lower right button (A), upper
right button (B), upper left button (C) and
lower left button (D) are pressed
simultaneously and released, an alarm
tone sounds after “INITIALIZE” is
displayed and the entire display is
illuminated (all-reset).
(4) When any one of the buttons is pressed
and released, the time and date are
displayed after “LOADING” is displayed.
(5) Correctly set the time, date and each mode by referring to the respective
sections of the instruction manual.
* Refer to “Using the Standard Mode: 1. Using the Time Mode” of this manual for
information on correcting the time and date.
(C)
(D)
(B)
(A)
English English English English English English
Charger
LED