Filter
Top Products
31
B. Setting the Time and Date
(1) The watch enters the correction state (display is flashing) when
the upper left button (C) is pressed for at least 2 seconds and
then released during any display of the time mode.
(2) The location on the display that is flashing changes in the order
shown below each time the upper left button (C) is pressed once.
• The watch returns to the normal display when the upper left button (C) is pressed and then
released in the contrast correction state.
(3) Correct the flashing item by pressing either the upper right button (B) or lower right
button (A).
• Pressing the upper right button (B) advances the display by one step at a time each time it is
pressed, while pressing the lower right button (A) moves the display back by one step at a time
each time it is pressed. (Pressing either button continuously causes the display to change
rapidly.)
• Refer to the section on "Locations Displayed by this Watch" for information on displayed
locations.
• The watch returns to 00 seconds when the upper right button (B) or lower right button (A) is
pressed. (If the seconds are between 30 and 59 seconds at that time the minutes advance by 1.)
• When the display is set to switching daylight savings time (ON or OFF is flashing) or switching
the 12H/24H format, the display switches back and forth between the settings each time the
lower right button (A) or upper right button (B) is pressed.
(4) Pressing and then releasing the lower left button (D) returns the watch to the normal
display.
* The year can be set from 2000 to 2099. However, January 1, 2000 is designated as a special
date for use by the hardware system of this watch. If the watch is attempted to be used for
infrared or USB communication or is switched to the low power mode while set to this date, all
the display elements on the watch are displayed and the watch returns to the initial setting (12:00
AM, January 1, 2003). Please do not set your watch to January 1, 2000.
* Once the date has been set, it is not necessary to correct for leap years or the end of the month.
(Dates such as February 30 that do not actually exist are not displayed even during correction.)
* Pay attention to AM (A) and PM (P) when using the 12 hour format.
* When daylight savings time has been set (ON), the time advances by 1 hour from the current
time and "ST" appears on the display. Daylight savings time cannot be set for Coordinated
Universal Time (UTC).
* The day is corrected automatically by correcting the year, month and date.
* The watch automatically returns to the normal display when none of the buttons are pressed for
about 3 minutes in the correction state (display flashing).
* The watch can be immediately returned to the normal display by pressing the lower left button
(D) and then releasing in the correction state (display flashing).
Flashing
Location
Contrast
(CONT)
12H/24H format
switching
Date Month Year
Daylight savings
time switching
Seconds Minutes Hours
(C) (C) (C) (C)
(C) (C) (C) (C)
(C)