Filter
Top Products
29
* The surface mode is no longer displayed once measurement of no fly time (timer) is completed
after scuba diving. The watch switches to the time mode of the standard mode when the lower
left button (D) is pressed in the skin diving log mode when the surface mode is not activated.
* When none of the buttons are pressed for about 3 minutes in any of the modes of the standard
mode, dive plan mode, scuba diving log mode or skin diving log mode, the watch automatically
returns to the time mode of the standard mode (except that it returns to the surface mode when
the surface mode has been activated).
* The watch switches to the low power mode when the lower right button (A) and lower left button
(D) are pressed for at least 2 seconds and then released in the time mode of the standard
mode.
* If "BATT", "ERR" or "CHK" is flashing in the lower left section of the display in any of the modes
(indicating that a warning function has been activated), and during correction in any mode, the
watch does not switch to the dive mode even if the water sensor gets wet.
* The hourglass mark or "LOADING" are displayed when switching to and from the dive mode,
infrared communication mode or low power mode. The water sensor along with all button
operations do not function while these are displayed.