Filter
Top Products
70
* When the watch has switched to the low power mode as a result of being insufficiently charged,
the watch does not return to the time mode of the standard mode even if the lower right button
(A) and lower left button (D) are pressed simultaneously for at least 2 seconds and then
released. In this case, the watch will only return to the time mode of the standard mode when
the watch has been sufficiently charged and the lower right button (A) and lower left button (D)
are again pressed simultaneously for at least 2 seconds. If the watch has been left not
recharged in the low power mode, it will become completely discharged and all the functions will
stop.
* When there is no display, the amount of current consumed is even less than during the time
display or date display.
2. Setting the Time and Date
(1) The watch enters the correction state (display is flashing) when
the upper left button (C) is pressed for at least 2 seconds and
then released during the time display or date display.
(2) The flashing item changes in the order shown below each time
the upper left button (C) is pressed and then released.
(3) Correct the flashing item by pressing the upper right button (B).
• Pressing the upper right button (B) advances the display by one step at a time each
time it is pressed. (Pressing the upper right button (B) continuously causes the
display to change rapidly.)
• The watch returns to 00 seconds when the upper right button (B) is pressed while
correcting seconds. (The minutes advance by 1 minute if the seconds are between
30 and 59 seconds at that time.)
• When switching the 12H/24H format, the display switches back and forth between
the 12 hour and 24 hour format each time the upper right button (B) is pressed.
(4) Pressing the lower left button (D) once returns the watch to the normal display.
* The time and date of the main location in the time mode of the standard mode can be displayed
and corrected in the low power mode. Changes made to the time and date in the low power
mode are retained even after returning to the time mode of the standard mode.
* The year can be set from 2000 to 2099.
* Dates such as February 30 that do not actually exist are not displayed even during correction.
* Pay attention to AM (A) and PM (P) when using the 12 hour format.
* The day is corrected automatically by correcting the year, month and date.
* The watch automatically returns to the normal display (time display or date display) when none
of the buttons are pressed for about 3 minutes in the correction state (display flashing).
* The watch can be immediately returned to the normal display by pressing the lower left button
(D) once in the correction state (display flashing).
Contrast
(CONT)
12H/24H format
switching
Date Month
Seconds Minutes Hours Year
Flashing
(C)
(C) (C) (C)
(C)
(C) (C)