Filter
Top Products
36
• When the upper right button (B) is pressed once while in the alarm number selection state (an
alarm number is flashing), the next alarm number is called up each time it is pressed. When
the lower right button (A) is pressed once in the alarm number selection state, the next alarm
number is called up in the reverse order each time it is pressed. Select "Silent" when you do
not want the alarm to sound.
• You can monitor the alarm corresponding to the flashing alarm number by pressing the upper
right button (B) or lower right button (A) in the alarm number selection state for as long as the
button is pressed. (The next or previous alarm number is momentarily displayed the instant the
button is pressed, while pressing either button continuously causes the set alarm to sound.)
(4) Pressing the lower left button (D) and then releasing finalizes the setting after which
the destination timer starts to run and the remaining time until the arrival time is
displayed.
* The 12 hour or 24 hour format setting is in accordance with the setting in the time mode.
* In the case the remaining time until the set arrival time exceeds 100 hours, the destination timer
stops at the arrival time display and then starts running automatically when the remaining time
until the arrival time is within 99 hours, 59 minutes and 59 seconds.
* When the arrival time has been set going back more than 100 hours, the destination timer stops
at the arrival time display.
* In the case of correcting the arrival time while the destination timer is running, the destination
timer starts running according to the newly set arrival time.
* The remaining time is recalculated in the case the time or daylight savings time setting is
corrected for the location set with the destination timer in the time mode or travel time mode
while the destination timer is running.
* The watch automatically returns to the arrival time display or remaining time display when none
of the buttons are pressed for about 3 minutes in the correction state (display flashing).
* The watch can be immediately returned to the arrival time display or remaining time display by
pressing the lower left button (D) and then releasing in the correction state (display flashing).
B. Destination Timer Measuring Procedure
Once the destination timer has been set, measurement begins automatically. Once the
timer reaches the arrival time, an alarm sounds for about 30 seconds informing you that
the time is up. After the time on the destination timer is up, elapsed time from the arrival
time flashes on the display for up to 99 hours, 59 minutes and 59 seconds. After this time
has elapsed, the watch returns to the arrival time display.
* The alarm that sounds when the arrival time is reached can be turned off by pressing any
button.
* If the alarm to inform of arrival is set to "Silent", arrival time is notified only with the "Dest"
display on the display.