Filter
Top Products
CYCLOPS (2001-12) R5976426 13-2
13.1 Faults
Faults cause/steps
no display: lamp not ignited and fan of the
illumination unit not running
The equipment is not connected to power sup-
ply. It must be supplied with suitable voltage
(see12.3 Technical Data Of Electrical System)!
Power switch is off. Switch on power switch.
See 5.1.3 Switching on
display is upside-down change the configuration:
To change the configuration of the projector,
proceed as follows:
Press ENTER to start up the adjustment
mode.
Press the cursor key up or down to select
'Installation'.
Press ENTER to display the Installation
menu.
Press the cursor key up or down to select
'Configuration'.
Press ENTER to display the Configuration
menu. The actual installed configuration
will be highlighted.
Press the cursor key up or down to select the
corresponding configuration.
the display is dark though the lamp is ignited there is no signal applied. Check the input source
and the connections
CYCLOPS can not be controlled via the RCU point the front of the RCU directly to the sensor
on the screen. When using the wireless remote
control, make sure you are within the effective
operating distance (30m, 100ft in a straight line).
The remote control unit will not function prop-
erly if strong light strikes the sensor window or
if there are obstacles between the remote control
unit and the IR sensor.
Check the batteries of the Remote Control Unit!
Table 13-1