Filter
Top Products
CYCLOPS (2001-12) R5976426 8-4
8.1.2 Edit File
The Edit file menu makes it possible to change the settings of the file according to the real settings
of the connected source. Consult the source specification before entering the data.
To start up the
EDIT menu:
Push the cursor key
up or down to highlight 'Edit'.
Press
ENTER to select.
The
Edit file adaptation menu will be displayed.
Select the file which must be edited (mostly the active file).
Press
ENTER.
The file name will be displayed in the upper right corner.
The following items can be adjusted:
Total quantity horizontal pixels
Active quantity horizontal pixels
Horizontal start (in pixels)
Horizontal period (in µs) (is automatically adapted during the installation of a file with
LOAD)
Total vertical lines (is automatically adapted during the installation of a file with
LOAD)
Active vertical lines
Vertical start (in lines)
Interlaced: toggle on/off (is automatically set to its correct position during the installation of a
file with
LOAD)
All settings can individually be changed by pushing the cursor key
up or down to select an item.
The color of the selected item will change. There are three methods to change the value.
method 1:
press ENTER to activate the digits
enter directly with the numeric keys on the
RCU or local keypad the new value
method 2:
Press ENTER to activate the digits
Push the cursor key
right or left to select the changing digit.
Push the cursor key
up or down to scroll to desired digit.
When finished press
ENTER to confirm.
method 3
Counting up or down by pushing the cursor key right or left.