Filter
Top Products
CYCLOPS (2001-12) R5976426 5-2
5.1 Power connection
5.1.1 AC Power (mains) cord connection
I
0
RC
RS 232 IN RS 232 OUT Comm. PortIEE 1394 TRIG MOUSEVIDEO S-VIDEO SDI SDO
R G B H/C V COMPUTER MONITOR AUDIO IN AUDIO IN AUDIO IN AUDIO OUTABC12
34 56
Use the supplied power cord to connect your projector to the wall outlet.
Plug the female power connector into the male connector [1] at the control panel.
The power input is auto-ranging from 95 to 230 VAC.
5.1.2 Fuses
For continued protection against fire hazard:
- refer replacement to qualified service personnel
- ask to replace with the same type of fuse.
Fuse type : T10 AH/250V
5.1.3 Switching on
Use the power switch [2] to switch on. When '0' is visible, the projector is switched off. When '1'
is visible, the projector is switched on.
When switching on with the
power switch, the projector starts in the standby mode. The projector
mode indication lamp is red.
5.1.4 Image projection
To start image projection:
press the
'Stand by' button once on the local keypad or on the remote control. The projector
mode indication lamp
will be green.
press a digit button to select an input source. The
projector mode indication lamp will be
green.
5.1.5 Lamp Run Time
The operation time of the lamp is 8000 hours. The total hours of operations are counted and can be
displayed on the screen.
The total lifetime of the lamp for a safe operation at high and constant brightness is
about 8000 hours. Always replace with a same type of lamp
1
2