Filter
Top Products
CYCLOPS (2001-12) R5976426 10-5
10.8 BARCO logo
The BARCO logo can be added to the image, in overlay or on a background, on any place on the
screen.
To add the BARCO logo or to change a setting in the
BARCO logo menu:
Push the cursor key
up or down to highlight 'BARCO logo'.
Press
ENTER to display the BARCO logo menu. The actual settings will be displayed.
Within this menu, three toggle settings and a shift control are available.
STATUS [ON/OFF] ON: BARCO logo will be displayed on the screen.
OFF: No BARCO logo displayed on the screen.
BACKGROUND [ON/OFF] ON: BARCO logo will be displayed on a black background.
OFF: BARCO logo will be displayed without any back-
ground.
SHIFT By pushing the cursor key up, down, left or right, the-
BARCO logo can be positioned anywhere on the screen.
HOT KEY [TEXT/OFF] OFF: no key on the RCU is used to display the BARCO logo
TEXT: the TEXT key on the RCU is used to display or to re-
move the BARCO logo with one single push on this key
(only in operational mode)..
10.9 Panel Adjustment
Changing these settings may seriously affect the performance of the projector.
Push the cursor key up or down to highlight 'Panel Adjustment'.
When
Panel Adjustment is selected in the Service Mode selection menu, the following warning
will be displayed :
Panel Adjustment is reserved to qualified service personnel.
If you are not qualified, press
EXIT to cancel the preset input balance.