Filter
Top Products
CYCLOPS (2001-12) R5976426 10-4
10.5 Change Baudrate PC
The communication speed between projector and computer, e.g. PC or MAC, has 8 possible
speeds. The baud rate speed can be software set. Handle as follows:
Push the cursor key
up or down to highlight 'Change Baudrate PC'.
Press
ENTER to display the Change Baudrate PC menu. The actual baud rate will be high-
lighted. The following baud rates are available:
230400/115200/57600/38400/19200/9600/4800/1200
Push the cursor key
up or down to highlight the desired baud rate.
Press
ENTER to select.
10.6 Reset Lamp Runtime
Reset lamp run time is only allowed when a new lamp is installed.
Push the cursor key
up or down to highlight 'Reset Lamp Runtime'.
Press
ENTER.
When
Reset Lamp Run Time is selected in the Service Mode selection menu, the following warn-
ing will be displayed :
Risk of electrical shock. Reset lamp run time is reserved to qualified service per-
sonnel.
If you are not qualified, press
EXIT to cancel the reset operation.
10.7 Lamp Runtime History
This item provides an overview of the different lamp runtimes
Push the cursor key
up or down to highlight 'Lamp Runtime History'.
Press
ENTER to display the overview Lamp RunTime History. A listing with the lamp serial
number and the corresponding runtime will be displayed. The actual installed lamp will be
marked.
Press
EXIT to return to the service mode selection menu.