Filter
Top Products
CYCLOPS (2001-12) R5976426 4-5
4.3.3 Terminology of keypad and RCU controls
1 Function keys have no function for this projector
2 ADJ ADJUST key, to enter or exit the adjustment mode.
3 Address key (recessed key), to enter the address of the projector (between 0 and
9). Press the recessed address key with a pencil, followed by press-
ing one digit button between 0 and 9.
4 Selection key to direct access the zoom/focus/shift functions.
5 PAUSE to stop projection for a short time, press 'PAUSE'. The image disap-
pears but full power is retained for immediate restarting.
6 Standby stand by button, to start projector when the power switch is switched
on and to switch off the projector without switching off the power
switch.
Attention : Switching to Stand-by.
When the projector is running and you want to go to stand-by, press
the stand-by key for 2 seconds until the message 'Saving data, please
wait' is displayed. Do not press any longer on the stand-by key
otherwise the projector will restart.
7 Mute to interrupt the sound reproduction.
8 Help on line help information (not yet available)
9 Digit buttons direct input selection.
10 Audio controls use these buttons to obtain the desired sound level
11 Picture controls use these buttons to obtain the desired picture analog level
12 PHASE used to remove the instability of the image.
13 Freeze press to freeze the projected image.
14 TEXT when adjusting one of the image, e.g. controls during a meeting, the
displayed bar scale can be removed by pressing 'TEXT' key first. To
re-display the bar scale on the screen, press 'TEXT' key again.
15 ENTER to start up the adjustment mode or to confirm an adjustment or se-
lection in the adjustment mode.
16 Cursor Keys (on
RCU) or '' and '-'
keys (cursor
keys) on the local
keypad
to make menu selections when in the adjustment mode or to
zoom/focus when the direct access is active.
Comparison between the cursor keys and the use of the '+' and '-'
keys on the local keypad
RCU local keypad
cursor key up '+' key up
cursor key down '-' key down
cursor key right '+' key right
cursor key left '-' key left
Use the '+' and '-' keys (cursor keys) to increase or decrease the ana-
log level of the image controls when they are first selected.
17 EXIT to leave the adjustment mode or to scroll upwards when in the ad-
justment mode.
18 RC operating
indication
lights up when a button on the remote control is pressed. (This is a
visual indicator to check the operation of the remote control)