CYCLOPS (2001-12) R5976426 8-6
Field Select: Default [both]
The field select is only used for interlaced images. One frame of an interlaced image contains
two fields, an even and an odd field. The choice exists to project [
both] fields on the screen or
only the [
even] or [odd] field. This can be useful for 3D projection. Use the ENTER key to tog-
gle between [
both], [even] and [odd].
Vertical Refresh [
sync/async]
The way of updating the image information on the LCD panels. Not available for PAL-NTSC-
SECAM sources. This option will be displayed in gray.
* For sources with a vertical frequency up to 60 Hz: the vertical refresh rate is the same as the
vertical frequency of the incoming source. This is a necessity to project moving images without
'motion artifacts'. For stationary images with a vertical frequency up to 60 Hz it is still possible
to use asynchronous refresh. When loading Pal, Secam, NTSC-files the synchronous mode is
default, for all other sources below 60 Hz asynchronous mode is default.
* For sources with a vertical frequency higher that 60 Hz: the vertical refresh is different than
the vertical frequency of the incoming source. Synchronous refresh cannot be used.
Vertical Sync Polarity [
leading] or [trailing]
The vertical refresh can be synchronized with the leading sync edge or trailing sync edge. De-
fault on [
leading].
Toggling to [
trailing] is only necessary for special applications where the trailing edge of the
sync signal has to be taken as a reference. Use the
ENTER key to toggle between [leading] or
[
trailing]
Press
EXIT to leave the Edit File Option menu.
A 'Confirm Edit File' menu will be displayed.
Press
ENTER to confirm and to save the new settings or EXIT to return without saving the new
entered settings.
8.1.3 Rename
To change the name of a selected file:
Push the cursor key
up or down to highlight 'Rename'.
Press
ENTER.
The
Rename selection menu will be displayed.
Push the cursor key
up or down to select a file name.
Press
ENTER to select.
The
Rename menu will be displayed with the selected file name already filled in the 'From file
name:'
area and in the 'To file name:' area.
The first character is highlighted.
Push the cursor key
left or right to select the desired character.
Change that character by pushing the cursor key
up or down. Numeric characters can be en-
tered directly with numeric keys on the
RCU.
Press
ENTER to confirm. The renamed file is entered in the list of files.
Press
EXIT to return to the Rename menu selection. No changes are made.
