Filter
Top Products
CYCLOPS (2001-12) R5976426 10-2
10.1 Identification
To display the
Identification screen:
Push the cursor key
up or down to highlight 'Identification'.
Press
ENTER to display the Identification screen.
The Identification screen gives an overview of:
type of projector Barcoreality Helios
projector address to change the address of the projector, see 10.4 Change Projector
Address
software version
installation configuration possible installations:
Front/Ceiling
Front/Table
Rear/Ceiling
Rear/Table
To change the installation configuration follow the instructions in
chapter 13.1 Faults.
baud rate transfer speed for communication with an IBM PC (or compatible) or
MAC. The baud rate of the projector must be the same as the baud
rate of the connected computer. When there is a difference, consult
chapter10.5 Change Baudrate PC.
text ON or OFF
projector serial number indicates the fabrication number of the projector. This number can be
useful when calling for technical assistance
projector run time gives the total run time since the first start up. All projectors leave
the factory with a run time of approximately 24 hours.
10.2 Change Password
This item is
password protected when the password strap is installed.
The
password function is enabled when the password strap on the controller module is installed.
Consult an authorized Barco service technician to change the strap position.
How to change the password:
Push the cursor key
up or down to highlight 'Change password'.
Press
ENTER to display the Change Password menu.
The old password is displayed and can be changed by entering the digit with the numeric keys
of the
RCU or local keypad.
Press
ENTER to save the new entered password.
Press
EXIT if no changes have to be made.