Filter
Top Products
CYCLOPS (2001-12) R5976426 11-2
11.1 General
For safety reasons, all servicing, including replacement of the lamp, is restricted to authorized per-
sonnel only!
Only authorized personnel should carry out maintenance work!
Never open the access cover without first disconnecting the power supply cord!
Measurements and tests with the opened device may be carried out only in the fac-
tory or by specially trained personnel, due to the dangers of electrical shock.
11.2 Cleaning
11.2.1 Cleaning the Screen
The screen is a high-precision optical component. It is made of plastic and is not
scratch-proof. Only use a soft, damp cloth when cleaning.
The following cleaning solutions can be used:
50% alcohol/water solution, e. g. Glassex;
soap/water solution (washing-up liquid).
The screen must only be wiped in a vertical direction!
11.2.2 Lens Cleaning Procedure
To minimize the possibility of damaging the optical coating or scratching exposed lens surface, we
have developed recommendations for cleaning the lens. FIRST, we recommend you try to remove
any material from the lens by blowing it off with clean, dry deionized air. DO NOT use any liquid
to clean the lenses.
Proceed as follows :
Always wipe lenses with a CLEAN Toraysee™ cloth.
Always wipe lenses in a single direction. Do not wipe back and forwards across the lens sur-
face as this tends to grind dirt into the coating.
Do not leave cleaning cloth in either an open room or lab coat pocket, as doing so can con-
taminate the cloth.
If smears occur when cleaning lenses, replace the cloth. Smears are the first indication of a
dirty cloth.
Do not use fabric softener when washing the cleaning cloth or softener sheets when drying the
cloth.
Do not use liquid cleaners on the cloth as doing so will contaminate the cloth.
Order number for a new Toraysee™ cloth : R379058.