Filter
Top Products
CYCLOPS (2001-12) R5976426 10-3
10.3 Change Language
To change the language of the control software:
Push the cursor key
up or down to highlight 'Change Language'.
Press
ENTER to display the Change Language menu.
Push the cursor key
up or down to highlight the desired language.
Press
ENTER to change the language. (Available languages: English)
10.4 Change Projector Address
Every projector requires an individual address between 0 and 255. This address can be software
installed. In addition the common addresse can be set to '0' or to '1'
To change the
individual address:
Push the cursor key
up or down to highlight 'Change Projector Address'.
Press
ENTER to display the Change Projector Address menu.
Push the cursor key
up or down to highlight Projector address
Press ENTER to select. The actual address will be filled in.
The first digit is highlighted. Enter the new projector address with the digit keys on the
RCU or
the local
keypad or push the cursor key left or right to select a digit and change the value by
pushing the cursor key
up or down until the new value is reached. Continue with the other dig-
its in the same way.
To change the
common address:
Push the cursor key
up or down to highlight 'Change Projector Address'.
Press
ENTER to display the Change Projector Address menu. The actual address will be filled
in.
Push the cursor key
up or down to highlight 'Common Address'
The first digit is highlighted. Enter the new projector address with the digit keys on the RCU or
the local
keypad or push the cursor key left or right to select a digit and change the value by
pushing the cursor key
up or down.
Valid common addresses are '0' and '1', exclusively.