Filter
Top Products
CYCLOPS (2001-12) R5976426 5-4
5.1.9 Set up of the input selection:
Press ENTER to start up the adjustment mode.
Press the cursor key
up or down to select 'Installation'.
Press
ENTER to display the Installation menu.
Press the cursor key
up or down to select 'Input Slots'.
Press
ENTER to display the Input slots menu.
In the Input slots menu the available input sources are marked with
x
Press the cursor key up or down to select 'Input Slots'.
Press
ENTER to toggle between [Manual] or [Automatic].
Press
EXIT several times to leave the adjustment mode.
Use of a RCVDS05 or VS05 :
When using a RCVDS05, it is recommended to use a 5-cable output module in the
RCVDS. The outputs of this module have to be connected to the 5 cable input
(slot 1) of the projector.
To switch the projector in the 5-cable mode see chapter
9 Installation Mode.
5.1.10 5-cable Input Slot (slot 1)
Slot 1 has 5 BNC input terminals.
The following signals can be connected to these BNC connectors:
Connector name R G B H V
Input signal
RGBHV R G B H V
RGBS R G B S -
RGsB R Gs B - -
Composite Video - Video - - -
Super Video - Y - - C
Component Video - SS R-Y Y B-Y S -
Component Video - SOY R-Y Ys B-Y - -
Slot 1 selection
To select slot 1:
Press the digit button
1 on the RCU or the local keypad.