Filter
Top Products
CYCLOPS (2001-12) R5976426 5-3
5.1.6 Switching to Stand-by
When the projector is running and you want to go to stand-by:
Press the
STANDBY key for 2 seconds until the message 'Saving data, please wait' is displayed.
Do not press any longer on the
standby key otherwise the projector will restart.
5.1.7 Switching Off
To switch off:
Switch off the voltage of the 24V interface or press
STANDBY key for 2 seconds. When the
message
'Saving data, please wait' is displayed, do not press any longer on the standby key
otherwise the projector will restart.
Let cool down the projector at least 10 min.
Switch off the projector with the
power switch.
When switching to standby, it is possible to restart within the first 5sec. When not
restarted within these first 5 sec., you have to wait one minute for being able to re-
start again. During the period when restarting is disabled the LED display will show
a jumping square with a dash. When restarting is enabled again, two dashes will be
displayed to indicate that the projector can be restarted.
5.1.8 Input Connections
The projector has multiple input connections for all common RGB and video sources. The input
can be selected either manually or automatically. When 'automatic' is selected in the
Input slots
menu,
by starting up the projector, it searches for an input source by scanning the inputs one by
one. If only one source is found, this source will be projected. If different sources are found, the
priority is as follows
input facilities priority of automatic input selection
Video 1
S-Video 2
5-cable input 3
Computer 4
Serial digital input never automatically selected
IEEE 1394 (not yet active) never automatically selected
When a RCVDS is connected to the projector, the 'Automatic' selection is disabled.