CYCLOPS (2001-12) R5976426 5-6
5.1.11 Computer input/Monitor output
Connect the output of the graphical card of the computer to the computer input of the projector
(connection < 60 cm) or insert an interface between the output of the computer and the input of
the projector.
Connect the monitor of the computer to the monitor output of the projector.
This monitor output is only available when the computer input is used as input.
Pin configuration of the D15 connector:
1 RED
2 GREEN
3 BLUE
4 loop through to monitor
5 ground
6 ground
7 ground
8 ground
9 loop through to monitor
10 ground
11 loop through to monitor
12 loop through to monitor
13 Horizontal/composite sync
14 Vertical sync
15 loop through to monitor
Slot 2 selection:
Press the digit button 2 on the RCU or the local keypad.
5.1.12 Video Input
Input signal:
Composite video signals from a VCR, OFF air signal decoder, etc...
1 x BNC or cinch 1.0Vpp ± 3 dB
No loop through.
Slot 3 selection:
Press the digit button 3 on the RCU or the local keypad.
