Filter
Top Products
Owner’s Manual: Advanced Programming and Troubleshooting 50
Changing Treadmill Settings
Through a specific set of number key presses, you can
customize the pause or cool down times and adjust the
maximum limit for the running belt speed.
To access the menu and change the settings, perform the
following steps:
1. At the banner, press the following keys in sequence
without pausing between selections:
PAUSE/RESET, 5, 6, 7, 1
Numbers appear on the display as you press the
associated key.
DIAGS - SET PARAMETERS scrolls across the display
followed by SAFETY CODE.
Selecting Safety Code Protection
When the treadmill is shipped from the factory, the safety
code protection feature is disabled. If you enable the safety
code, the display prompts you to enter the safety code at the
beginning of your exercise session. The running belt will not
move unless the proper 4-digit safety code is entered.
If the correct code: 1, 2, 3, 4, is not entered within 30
seconds, further access is denied. Refer to Entering the
Safety Code.
2. At the SAFETY CODE prompt, press OK. Use a
navigational arrow key to alternate between the two
selections.
CAUTION: Do not assume the treadmill is safe
because of safety code protection. Never leave
children unsupervised around the treadmill.
3. When you are ready, press OK to accept the display
setting and move to the next program. Or, press PAUSE/
RESET to return to the banner.
Setting Description
ENABLED Causes the safety code prompt to appear
prior to a workout and when returning
from pause mode.
DISABLED Does not require a safety code to operate.
M9.33-931_Owners Manual.book Page 50 Friday, January 11, 2008 7:42 AM