Cybex International 710T Treadmill User Manual


 
grounded, dedicated circuit, and one of the following: 115 VAC, 60 Hz and 20 amps, or 230
VAC, 60 Hz, and 15 amps, or 220/240 VAC, 50 Hz and 15 amps. Make sure that the treadmill
is connected to an outlet having the same configuration as the plug. Do not use a ground
plug adapter to adapt the power cord to a non-grounded outlet.
Important Safety Instructions
(Save These Instructions)
! DANGER: To reduce the risk of electric shock, always unplug this treadmill from the
electrical outlet immediately after using it and before cleaning it.
! WARNING: Serious injury could occur if these precautions are not observed. To reduce
the risk of burns, fires, electric shock, or injury:
Obtain a medical exam before beginning any exercise program.
Keep children away from the treadmill. Teenagers and disabled persons must be
supervised while using.
Stop exercising if you feel faint, dizzy, or experience pain at any time while exercising and
consult your physician.
Use the treadmill handrails for support and to maintain balance.
Use caution when mounting and dismounting the treadmill.
Disconnect all power before servicing the treadmill.
Use a dedicated line when operating the treadmill.
Connect the treadmill to a properly grounded outlet only.
Do not operate electrically powered treadmills in damp or wet locations.
Keep the running belt clean and dry at all times.
Stop and place the treadmill at 0 degrees incline (level) after each use.
Do not leave the treadmill unattended when plugged in and running. After turning off the
treadmill, don't leave it until it comes to a complete stop and is level. To disconnect, turn
all controls to the STOP or OFF position, and then remove the plug from the outlet.
Inspect the treadmill for worn or loose components before each use. Do not use until worn
or damaged parts are replaced.
Maintain and replace worn parts regularly. Refer to “Preventive Maintenance” Section of
Owner's Manual.
Cybex 710T Treadmill Owner’s Manual
Page 1-2