Filter
Top Products
9. Run the treadmill through its full % grade range. Press and hold the INCLINE
^
key until
the treadmill reaches its highest grade (15%). Then press the INCLINE v key until the
treadmill is back to 0% grade.
10. Press STOP three times to stop the running belt, end the checkout session, and return
the display to Dormant Mode.
Finish your setup of the 710T by setting the operation options as desired.
Setting Operation Options
The 710T allows you to configure the following features:
1. Metric/English Measurement Units
2. Programs On/Off Mode
3. Time Limit
4. Speed Limit
5. Pause Time
6. Service Reminders
1. Metric/English Measurement Units
You can change the settings to metric units, or back to English units. With the treadmill in the
on (I) position and in Dormant Mode, press and hold the STOP and + buttons at the same
time for two seconds. The display will show “METRIC”. To change to English, press and hold
the STOP and - keys at the same time for two seconds and the display will show “ENGLISH”.
NOTE: The next four features can be changed after entering Diagnostic Tests. To enter
Diagnostic Tests, press and hold SCAN/SAVE, then press -.
2. Programs On/Off Mode (C14)
The programs on/off mode can be used to prevent or “lock out” the use of the 710T's
programs, for Manual Mode use only.
To enter Diagnostic Tests, press and hold SCAN/SAVE, then press -. You will see the
message “DIAGNOSTIC TESTS”. Press v or
^
or to scroll to ”C14 PGM LOCKOUT”. Press the
+ key to turn the lockout feature on, disabling all programs. Press the - key to turn the lockout
features off enabling all programs. Press START/ENTER to confirm, and again to save. Press
^
to scroll to C15.
Cybex 710T Treadmill Owner’s Manual
Page 5-10