Filter
Top Products
Test the 710T Operation
Use the following instructions to test the full speed and incline range of the
treadmill and to check the belt for proper operation.
! CAUTION During this procedure STAY OFF THE RUNNING BELT!
Stand with your feet on the side platforms.
1. Without anyone on the treadmill, plug the power cord into the front end of
the treadmill and into a power outlet from a grounded, dedicated circuit,
and 115 VAC, 60 Hz and 20 amps, or 230 VAC, 50 Hz, and 15 amps, or
208/220 VAC, 60 Hz and 15 amps.
2. Locate the on/off (I/O) power switch on the front of the treadmill. Toggle it
to the on position (I).
3. The control panel will light up and continuously display information on
available programs when the treadmill is in Dormant Mode with the on/off
power switch turned on (I) and the treadmill power cord plugged in. (Cybex
recommends that the treadmill be unplugged or the On/Off (I/O) power
switch turned Off (O) when it is not in use.)
NOTE: Cybex recommends that the treadmill be unplugged or the on/off
(I/O) power switch turned off (O) when it is not in use.
4. Press the START/ENTER key three times, first to enter the Selection Mode
menu, second to accept the default of Manual Mode and third to accept
the default weight.
5. The treadmill begins a countdown in the display window, “3...2...1,” and
sounds a tone for each count. After it reaches one (1), the treadmill
gives a steady tone, and then starts accelerating the belt to reach 1 mph
(1.6 kph).
6. Without standing on the running belt, press and hold down the SPEED +
key until the treadmill reaches a speed of approximately 4 mph (6.4 kph),
as indicated on the display.
7. Observe the belt to see that it is running properly; it should stay centered in
the middle of the deck. If you have problems with the running belt
operation, see Running Belt Adjustments in the Preventive Maintenance
chapter.
8. Press and hold the SPEED + key until the treadmill reaches its highest
speed, 10 mph (16.1 kph). Then press the SPEED - key until the treadmill
is back to 1.0 mph (1.6 kph).
Cybex 710T Treadmill Owner’s Manual
Page 5-9
2 Technical Specifications
Specifications . . . . . . . . . . . 2-1
3 Operation
Quick Operation Guide . . . . 3-1
Detailed Operation Guide . . 3-1
Stopping the Treadmill. . . . . 3-3
Control During Operation . . 3-4
Data Readouts. . . . . . . . . . . 3-5
Selecting Programs
& Options . . . . . . . . . . . . . 3-6
Displaying Heart Rate . . . . . 3-6
Use of Programs . . . . . . . . . 3-7
Manual Mode . . . . . . . . . . . 3-8
P1 - Fitness Test Program. . 3-8
P2 - Weight Loss Program 3-10
P3 - Cardiovascular Program 3-12
P4 - Speed Challenge
Program . . . . . . . . . . . . . 3-14
P5 - Express Program. . . . 3-16
P6 - Hill Interval Program . 3-17
P7 - Speed Interval
Program . . . . . . . . . . . . . 3-18
P8 - Pike’s Peak Program . 3-19
P9 - River Run Program . . 3-20
P10 - 5 Kilometer Program 3-21
P11 - Demonstration
Program . . . . . . . . . . . . . 3-22
P101-P110 - Saved
Program . . . . . . . . . . . . . 3-22
Workout Tips. . . . . . . . . . . 3-24
4 Preventive Maintenance
Regular Maintenance
Activities. . . . . . . . . . . . . . 4-1
Cleaning Your Treadmill. . . . 4-1
Running Belt Maintenance . 4-2
Other Preventive
Maintenance . . . . . . . . . . . 4-6
Service Schedule . . . . . . . . . 4-7
Log Sheet. . . . . . . . . . . . . . . 4-8
5 Setup & Assembly
Quick Setup . . . . . . . . . . . . 5-1
Choosing & Preparing a Site 5-1
Electrical Power
Requirements. . . . . . . . . . 5-3
Unpacking. . . . . . . . . . . . . . 5-3
Assembling the Treadmill. . . 5-4
Testing the 710T Operation. 5-9
Setting Operation Options. 5-10
6 Customer Service
Contacting Service . . . . . . . 6-1
Serial Number & Voltage . . . 6-1
Warranty . . . . . . . . . . . . . . . 6-1
Return Material Authorization . .
(RMA) . . . . . . . . . . . . . . . . 6-4
Damaged Parts . . . . . . . . . . 6-4
Ordering Parts. . . . . . . . . . . 6-5
7 Service
Service Instruction . . . . . . . . 7-1
Motor Brushes. . . . . . . . . . . 7-1
Motor Current & Voltage . . . 7-4
Running Belt & Deck . . . . . . 7-7
Drive Belt. . . . . . . . . . . . . . . 7-9