Filter
Top Products
7
620-7920 Rev A
Step 3.
Position neck close to the service opening in
the front of treadmill so the cables go into the
opening first.
Step 4.
Route all cables from neck into motor compart-
ment through lower neck service opening.
Caution: Make sure not to pinch any cables.
Step 2.
Remove the neck form shipping box and verify
the cables are properly fed through attached
protective tube in the base of the neck.
Note: The tube will protect cables from getting
pinched during installation and will make it easier to
route them through service opening.
Step 1.
Lift the front motor shroud off of the frame as-
sembly.
Note: Make sure the shroud is properly stored to
prevent damage.
INSTALLATION INSTRUCTIONS