Filter
Top Products
13
620-7920 Rev A
Step 27.
Secure the power cable to the frame with the tie
-strap and cut excess strap.
Caution: Make sure not to damage the power cord
.
Step 25.
Install left and right handrail grommets. Slide
the grommet down the rail and snap it in place
over the bed rails covers. Push down and ro-
tate the grommet slightly to seat the tabs into
the plastic covers.
Note: Make sure the grommet is tightly secured in
place.
Step 28.
Position the treadmill in its place. If leveling the
treadmill is necessary, loosen the lock nuts of
the leveling feet, rotate the feet until the tread-
mill is stabilized, then re-tighten the lock nuts.
Step 26.
Insert the power cord through the tie wrap loop
below motor compartment and connect it to the
power receptacle.
Note: Don’t turn on the power switch yet.