Filter
Top Products
23
SETTING THE PRIMARY MEASUREMENT DISPLAY
If you are in the Time of day display press SELECT three times.
Int is displayed.
Press SET/START/STOP until you enter the mode for setting the primary
measurement display.
Chrono (alternatively TIME or LAP) is flashing.
00:00 0 (alternatively time of day) is displayed.
1. Press SIGNAL/LIGHT to select the desired primary measurement
display. The alternative you choose will be displayed in the
middle row during the heart rate measurement.
CHOOSE FROM THESE ALTERNATIVES:
CHRONO 00:00 0 displays the total exercise time.
You will see lap time in the upper row of the display during the
measurement.
TIME displays the time of day (for example 1:52 PM/13:52).
You will see lap time in the upper row of the display during the
measurement.
LAP 00:00 0 displays lap times. Lap times can be taken by pressing
STORE/LAP/RECOVERY.
You will see the number of the lap in the upper row of the display
during the measurement.
According to the alternative you choose for the primary measurement
display you will see the secondary measurement display during the heart
rate measurement by using the Polar Heart Touch ( Polar Glossary).
For more details see Functions during the heart rate
measurement/Checking the secondary measurement displays.
Choose from the following two alternatives to continue:
1. To turn the interval function ON or OFF press SET/START/STOP.
The uppermost block of the graphic bar is flashing.
Continue from Setting the Interval function.
2. To return to the Time of day display, press SELECT twice.