Filter
Top Products
18
B. Heart rate measurement mode (Int is OFF):
Two timers in use.
1. Press SIGNAL/LIGHT to turn the timer function
ON or OFF.
2. Press STORE/LAP/RECOVERY to confirm
your selection.
The minutes of Timer 1 are flashing.
3. Press SIGNAL/LIGHT to select the desired
number of minutes.
4. Press STORE/LAP/RECOVERY to confirm
your selection.
The seconds of the Timer are flashing.
5. Press SIGNAL/LIGHT to select the desired
number of seconds.
6. Press STORE/LAP/RECOVERY to confirm
your selection.
7. Press SET/START/STOP to set Timer 2.
ON or OFF is flashing.
8. Repeat the steps 1 to 6 to set Timer 2.
Timer 1 starts running when you start the stopwatch. You will hear one
beep when the time of timer 1 is up. Timer 2 will start automatically
after the beep. You will hear two beeps when the time of timer 2 is up.
If you only set timer 1, it will not repeat itself. When the time is up,
you will hear 6 beeps.
Timer 2 cannot be set if TIM 1 is switched OFF.
If you accidentally pass the digit you wanted to enter, press and
hold SET/START/STOP to restart from 00.
Choose from the following two alternatives to continue:
1. To set Heart rate limits 1, 2 and 3 press SET/START/STOP.
The third block of the graphic bar is flashing.
LIM1 is displayed.
The reading representing the upper limit 1 is flashing.
Continue from Setting the heart rate limits.
2. To return to the Time of day display press SELECT twice.