Filter
Top Products
6
700 Tm Owner’s Manual
Safety Instructions & Warnings (continued)
used in the area.
14. Keep the treadmill away from walls to allow proper ventilation. Air should be able to circulate
freely around the unit. Keep all air openings free of dirt and dust.
15. To ensure proper functioning of your treadmill, do not install attachments or accessories not
provided or recommended by Diamondback.
16. Place the treadmill in an area that will meet minimum clearance requirements: Front & Sides:
1 ft / 30 cm, Back 6 ft./ 180 cm
17. Always wear proper clothing and shoes when exercising on the treadmill.
18. Do not stand on the tread belt while performing auto-calibration.
19. Never walk or jog or run backwards on the treadmill.
20. Higher speed and higher incline is not for everyone. It is designed for occasional use of a skilled
runner and may exceed many users’ capabilities. Stop right away if you feel any discomfort.
21. Use this treadmill only for its intended use as described in this manual. User weight is not to
exceed 350 pounds / 159 kilograms.
22. Use the handrails when getting on and off your treadmill.
23. Do not remove the treadmill covers or other components. Only an authorized Diamondback
Fitness dealer should perform service.
GROUNDING INSTRUCTIONS
This product must be grounded. If it should malfunction or breakdown, grounding provides a path of
least resistance for electric current to reduce the risk of electric shock. The treadmill is equipped with
a cord having a grounding conductor and grounding plug. The plug must be plugged into an appro-
priate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
DANGER
Improper connection of the grounding conductor can result in risk of electric shock. Check with a
qualified electrician or serviceman if you are in doubt as to whether the treadmill is properly
grounded. Do not modify the plug provided with this product- if it will not fit the outlet, have a
proper outlet installed by a qualified electrician.
Your treadmill is for use on a 120 volt circuit and has a grounding plug that looks like the one
illustrated in the picture above. Make sure the treadmill is connected to an outlet having the same
configuration as the plug. Do not use an adapter with your treadmill.
SAFETY KEY CLIP & TETHER
• Your treadmill will not start unless the safety key is placed on the proper location of treadmill console.
• Attach the safety key clip properly onto your clothes before operating treadmill.
• In case of an emergency, pull the safety key off the treadmill, it will cut off the power to the
console and stop the treadmill immediately.
• Place the safety key back in place, the treadmill will resume back to idle mode.
• Contact your dealer for a safety key replacement if you do not have one.
SAVE THESE INSTRUCTIONS
Place this clip onto
your clothes before
you styart using
treadmill.
Figure
Grounding
Methods
Grounded
outlet
Grounding
pin
Use open wrench to
adjust the leveling pad
here.
700tmOM 8/24/06 11:15 AM Page 8