Filter
Top Products
8
1
2
4
3
Attach the front leg.
• Remove the two screws from the respective leg pipes. The one with
casters should be used as front leg.
• Place the front leg under the front end of the main body with casters
facing forward, and adjust the position so that the screw holes meet
the fastening points.
• Fasten the leg with the two screws securely.
Attach the rear leg.
• Place the rear leg pipe under the rear end of the main body, and
adjust the position so that the screw holes meet the fastening points.
• Fasten the leg with the two screws securely.
Mount the handlebar post.
• Remove the handlebar post knob.
• Insert the handlebar post into the main body, with the post holes
facing forward.
• Adjust the handlebar height so that one of the post holes meets the
post knob screw hole, and fasten the post knob securely. It will be
easier to screw in if you slightly lift the handlebar post.
Mount the saddle.
• Loosen the bolt of the seat pillar using the wrench provided.
• Tighten the two rods under the saddle with the clamp.
• Tighten the bolt of the seat pillar and secure the saddle.
O
N
O
F
F
Caster
Front
Screw
Front leg
Screw
Rear
Tighten
Loosen
Handlebar post
Handlebar post knob
Seat pillar
Wrench