Filter
Top Products
11
Adjust the saddle angle.
• Loosen the bolt of the seat pillar using the wrench provided.
• Adjust the saddle to the desired angle.
• Tighten the bolt of the seat pillar, fixing the angle of the saddle as
desired.
Adjust the pedal belt.
• The pedal belt length of the EC-C400 can be adjusted according to
your shoes size.
The level knobs
• Ideally, you should only use your exerciser on a hard, level floor.
• If the exerciser tilts or wobbles during use, turn one or more level-
ling knobs until a stable position is maintained.
Adjusting all parts to fit
•Make various height and angle adjustments so that your posture
when seated on the exerciser is like that shown in the diagram be-
low.
• For proper saddle height, your knees should be slightly bent when
the pedal is at its lowermost position.
• For proper handlebar height and angle, you should be leaning
slightly forward when holding the handlebar.
•When you move the exerciser, face the handlebars, pull handlebar
forward, lifting the rear or exerciser, roll the exerciser on its direc-
tion.
Caution: Firstly, check that the handle is tightened.
Caution: Do not lift the bike by the seat to move it. Tilt the bike
by using handlebars as shown in diagram to more the
bike. Lifting the seat can cause damage to the seat.
4
6
7
5
Seat pillar
Wrench
Lower
Higher
Leveling knobs
EC-1200