Filter
Top Products
FIGURE 39
3/8 X 2-3/4"
DETAIL 39
STEP 39
Securely assemble the ball end of the AB CABLE (103) and one 3-1/2" PULLEY (42) to the FRONT UPRIGHT (25) using
8 X 2-3/4" BOLTS (85), two 3/8" FLANGE SPACERS (49), two 3/8" WASHERS (91), and two 3/8" LOCKNUTS (92). (NOTE:
AB CABLE (103) should be routed underneath the retaining bolt as shown in DETA~I, 39.)
FIGURE 40
STEP 40
¯
Rtmthe AB CABLE (103) throughflle
floating pulley assembly, then screw the
threaded end of AB CABLE (103)
approximately 3/4" into the end of the
PULLEY BRACKET (29) and tigtttenjam
nut securely as shown in FIGURE 40.
IiM~PORTANT! Make sure the cables are
running in the grooves of all pulleys.
34