ParaBody 425103 Home Gym User Manual


 
STEP 45
If upon completion of assembly, the HEAD PLATE (72) does not
sit on top of the first WEIGHT PLATE (105), push the t-~AD
PLATE (72) down, insert the WEIGHT STACK PIN (75)
perform severalrepetitions at the press station. This will relax the
cable system and prevent the HEAD PLATE (72) from lifting up.
If after completing previous step, theHEAD PLATE (72) still does
not sit on top of the first WEIGHT PLATE (105) or ffthere
excess slack in the cable system, adjust the woo threaded ends of
the HEAD PLATE CABLE (102) accordingly and ~fighten thejam
¯ If there is excess slackin tim AB or PEC DEC cable system, adjust
the threaded end of the AB CABLE (103) accordingly and re-
tighten the jam nut.
FIGURE 45
FIGURE 46
STEP 46
¯ Apply pressure to the bottom of one St~OUD (31) where thw"V" groove is and carefuly remove the weight stack opening on the plastic
SHROUD (31 ) as shown in 171GURE 46. This will be the front SHILOUD (31
¯ Apply one PARABODY 425 SF~I0//$ STF£L LABEL (32) ~o the front SHROUD (3 I) approxdmately 2" from the top as shown in FIGUR.E
46.
38