Filter
Top Products
FIGURE 37
STEP 37
¯
Assemble one 3-112" PULLEY (42) around the PEC DEC CABLE (98) and to the PULLEY BRACKET (29) using one 3/8
BOLT (84), two 3/8" WASHERS (91) and one 3/8" LOCKNUT (92) as shown in FIGURE
STEP 38
\ \ CABLE
"~
/
FIGURE 38
Slide the ends of the PEC DEC CABLE (98) into the bushings on the PEC CAMS (24) as shown on FIGURE
Lay the PEC DEC CABLE (98) over the pulleys and under the cable retaining dips in the CENTER PULLEY BRACKET (26)
sho~m in FIGURE 38. (NOTE: Securely tighten the pulley connections in the CENTER PULLEY BRACKET (26).
cable retaining dips should be at approximately a 45
°
angle.)
[ 1/2 [ 1/2 [ 1/2 [ 1/2 [ 1/2 [ 1/2 ]
3 4 5 6
0
1 2
, , ,, ] [ i , ] i i i ] , ,_j ] , i
33