ParaBody 425103 Home Gym User Manual


 
FIGURE 21
STEP 21
¯ Insert two 3/4" FLANGE BEARINGS (76) into the PRESS ARM (27) as shown in FIGURE
¯
Hold the PRESS ARM (27) between the REAR (4) and M~DLE UPRIGHTS (8) and slide the 3/4 DIA X 11" SHAFT
throught the MIDDLE UPRIGHT (8), PRESS ARM (27), and through the collar on the REAR UPRIGHT (4). To SECURE
SHAFT (107) in place, insert two 5/16" SET SCREWS (48) into the collars on the UPRIGHTS and tighten. See FIGURE
¯ Insert two 1/2" FLANGE BEARINGS (78) into the PRESS ARM (27) as shown in FIGURE
FIGURE 22
STEP 22
1/2 X 3"
Assemble the RECEMNG TUBE (13) to the PRESS ARM (27) using one 1/2 X 3" BOLT (87) and one 1/2" LOW HEIGHT
NUT (95). (NOTE: Tighten the connection enough to remove play, yet allowing the PRESS ARM (2) to rotate freely.)
FIGURE 22.
20