Filter
Top Products
FIGURE 17
~ ~LOW HEIGHT NUT
1/2 X 3"
STEP 17
¯
Iusert two 1/2" FLANGE BEARINGS (78) into*he LEG CURL/EXT (15) as shown onFIGURE
¯
Assemble *he LEG CURL/EXT (15) to *he FRONT UP1LIGHT (25) using one 1/2 X 3" BOLT (87) and one 1/2" LOW
NUT (95). (NOTE: Tighten the connection enough to remove play, yet allowing the LEG CURL/EXT to rotate freely.)
¯
Assemble two ROLLER PADS (37) to *he ROLLERPAD ADJUST (11) using two STARLOCK COLLARS (50).
¯
SECURELY assemble one 3/8" SPRING PIN (51) to the ROLLER PAD ADJUST (ll) as shown in FIGURE17.
-. Slide ROLLER PAD ADJUST (11) over *he LEG CURL/EXT (15) until *he spring pin pops into *he holes. See FIGURE
¯
SECURELY assemble one 3/8 X 1" BUTTON HEAD CAP SCREW (96) and one 3/8" LOCKNUT (92) to *he last hole in
LEG CURL/EXT (15) as shown in FIGURE 17.
¯ Insert one 2" SQ. END CAP (46) into *he end of the LEG CURL/EXT (15) as shown in FIGURE
16