ParaBody 425103 Home Gym User Manual


 
STEP 23.
I
SPRING PIN
ASSEMBLY
PUSH/PULL--~
CABLE \
\
-- 1/4" NUTS
130 ]~OT OVERTIGH’~N!
DETAIL 23
¯
SECURELY assemble the SPRING PIN ASSEMBLY of the PUSH/PULL CABLE to the SPRING PIN BAtLREL on the RECEIV-
ING TUBE (13). (!!! IMPORTANT !!! TIGHTEN THE NUT OF THE SPRING PIN ASSEMBLY SECU]LEL!0
¯
Swing the PRESS ARM (27) up until the SPRING PIN of the PUSH/PULL CABLE engages in one of the adjustment holes.
¯
Thread the second 1/4-28 IN.NUT onto the threaded end of the CABLE, and cinch the two 1/4-28 IN. NUTS around the flat.
(IM:PORTANT! D O NOT OVER TIGBTEN NUTS!)
¯ Use the extra thread on the end of the CABLE to adjust out slack. ( !!! D O NOT ADJUST OUT TO I~A~R ! !! ALWAYS ALLOW
SPRING PIN ASSEMBLY TO FULLY ENGAGE)
STEP 24
FIGURE 24
¯
SECURELY assemble the SEAT PAD (40) to the
BACK PAD ADJUST (16) using four 3/8 X 1-1/4"
BOLTS (83) and four 3/8" WASHERS (91).
FIGURE 24.
¯
SECURELY assemble one 3/8" SPRING PIN
ASSEMBLY (51) to the FRONT UPRIGHT (25)
shown in FIGUR~ 24.
Insert the SEAT PAD (40) & ]BACK PAD ADJUST
(16) into the FRONT UPRIG~qT (25) while pulling
back on the SPRING PIN AS SEMBLY (51) until
engages in one of the adjustment holes. See FIGURE
24.
[
112
[
1/2 [ 1/2 [
1/2 [
1/2 [ 1/2
6
3
4
[ I I A_
0 1
I I I l
21