Filter
Top Products
X 4-1/2"1
FIGURE 31
;TEP 31
¯ SECURELY assemble the PRESS SUPPOt<T TUBE (21) to the PRESS SWIVEL (10) using one 1/2" :X~ 4-1/2" BOLT ~89)
one 1/2" LOW HEIGHT LOCK NUT (95). (NOTE: Tighten the connection enough to remove play, yet allowing the PRESS
SUPPORT TUBE to rotate freely).
¯
SECURELY assemble the PRESS BACK SUPPO1LT (23) to the PRESS SUPPORT TUBE (21) using o:.~e 1/2" X 3" BOLT
and one 1/2" LOW HEIGHT LOCK NUT (95). (NOTE: Tighten the eo~meetion enough to remove I~lay, yet allowing
PRESS BACK SUPPORT to rotate freely).
¯ SECURELY assemble one 1/2" SPRING PIN ASSEMBLY (52) to the springpin housing on the PRES;~ SUPPORT TUBE (21).
(NOTE: Tighten the nut of the SPRING PiN ASSEMBLY SECURELY.)
¯ SECURELY assemble the BACK PAD (39) to the PRESS BACK SUPPO1LT (23) using two 3/8 X 2-3/4
~"
BOLTS (85) and two 3/8"
WASHERS (91). See FIGURE 31.
[ 1/2 I 1/2 I 1/2 I 1/2 I 112
6
o
I, I,,,
27