ParaBody 425103 Home Gym User Manual


 
FIGURE 32
STEP 32
¯ To assemble the D-RING CABLE (102) follow the cable routing as shown and use the following steps:
¯ Screw one of the threaded ends of the D-RING CABLE (102) approximately 1" into the end of the SELECTOR SHAFT (73)
the HEAD PLATE (72) asshown in FIGURE 32.
¯ Route the CABLE (102) up and over the two PULLEYS in the TOP BOOM (17) above the WEIGI-rI STACK. (Remove pulleys
for ease of installation.)
¯
Screw the other threaded end of the D-RING CABLE (102) approximately 1" into the end of the £aaft on the D-RING (7)
shown in FIGURE 32.
SECURELY tighten two pulley connections from the previous step.
[ 1/2 [
1/2
l
I/2 [
1/2
I
3 4
29
1/2 I 1/2
6