Filter
Top Products
1-1/4"
FIGURE 11
STEP ll
¯
SECURBLY assemble the SELECTOR SHAFT (73) to the EEAD PLATE (72) using one 3/8 X 1-1/4" BOLT (83) and 318"
WASHER (91).
¯
Insert two GUIDE RODS (36) into the BASE (1) as shown on FIGURE 11. (NOTE: Lubricate GUIDE RODS (36)
silicon or teflon spray available at most hardware stores.)
¯
Slide two 1-1/4 SQ. X 4-7/8" TUBES (34), two 3/4" WASHERS (71), and two WEIGHT STACK CUSI-IIONS (70) - IN
ORDER - down over the GUIDE RODS (36).
¯
Using EXTREME CARE slide all fifteen WEIGHT PLATES (105) down over the GUIDE RODS (36) on to the WEIGHT STACK
CUSHIONS (70). Make sure that the keyholes of the WEIGHT PLATES (105) are all facing the right wa,.h
¯
Slide the head plate assembly down over the GUIDE RODS (36) onto the weight stack.
¯
Insert four CAP PLUGS (106) into the top and bottom ends of the GUIDE RODS (36) as shown in FIGURE
¯
Attach the WEIGHT STACK LABELS (104) to the weight stack. Also insert the WEIGHT STACK PIN (’75) imo tim first
WEIGHT PLATE (105) of the weight stack.
11