4-16
Making Settings
Enabling the fixed settings feature
Follow these steps to enable the fixed settings feature.
1. Make sure that Manual is selected as the camera mode.
See “Making camera mode settings” on page 4-5 for
details.
2. Turn the camera’s dial switch to the position and
press the Shot SETUP button.
3. Press the FixSet button to select On. Then press the
Back button.
Proceed to the next section for details on saving your fixed
settings.
Saving your fixed settings
Follow these steps to save your fixed settings.
1. After you have enabled the fixed settings feature, turn
the dial switch to .
Note:
You cannot use the fixed settings feature when taking
pictures using the viewfinder.
2. Press the button at the top-right of the LCD monitor
several times until Fixed Settings is displayed.
3. Take a picture. After the camera processes the photo,
the exposure settings that were used for that photo are
displayed on-screen.
To save the displayed settings, press the Yes button.
If you do not want to save the displayed settings, press
the No button. Repeat this step until you are satisfied
with the displayed settings.
4. To take a picture using the saved settings, simply frame
a shot and press the shutter button. To exit the fixed
settings feature, click BACK.
Note:
To use the fixed settings after exiting this screen, see
the next section.
To see the current fixed settings, press the Fixset Info
button.
To erase the current fixed settings from the camera’s
memory, press the Fixset Cancel button.
