1-8
Getting Started
2. Insert four batteries into the compartment, positioning
the + and - ends as shown below. Then lower the battery
cover.
Note:
Do not use different types of batteries together; this can
cause fire or explosion.
3. Swing the battery cover shut and hold it down while
you slide it back to lock it, as shown below.
When the battery power is almost out, a low battery icon
appears on the display panel. When the battery power
runs out, this icon blinks and the camera turns off
automatically. Remove and recharge your batteries, then
reinstall the batteries.
Note:
When the battery level is low, the LCD monitor turns off
while the flash is being charged. When the charging is
complete, the LCD monitor turns back on.
Replacing the batteries
Replace your PhotoPC 3000Z batteries when the low battery
icon appears on the camera’s display panel. Be sure
to replace all four batteries at the same time. You can replace
them with either of the following battery types.
Single-use AA (IEC LR6) alkaline batteries
Rechargeable AA Ni-MH batteries
