A SERVICE OF

logo

Open as PDF
next previous
1-12
Getting Started
2. Tighten the screw sleeve on the fastener as shown
below to close it.
3. After securely closing the fastener, turn it so that the
screw sleeve is covered by the strap, as shown below.
4. Repeat steps 1 through 3 to attach the other end of the
strap to the other side of the camera.
Attaching the lens cap to your camera
After you have attached the camera strap, you can attach the
lens cap to your camera using the lens caps string. To attach
the string to the lens cap and then to the camera, follow these
steps.
1. Pass the end of the string with the smaller loop through
the eyelet on the edge of the lens cap, then pass the
other end of the string through the smaller loop and pull
it tight as shown below.
screw shut to secure