Filter
Top Products
• To teach a new sensor, make sure you are not near (40 m/131 ft) other Speed sensors. Then select
Yes to confirm teaching. Start test drive is displayed. Rotate the wheel a few times to activate the
sensor. A flashing red light indicates that the sensor is activated. Completed!! is displayed once the
teaching process is over. The cycling computer is now ready to receive speed and distance data.
• Select No to cancel teaching and the already earlier taught speed sensor is taken into use.
Once the speed sensor is taught to recognize the cycling computer, it will do so even if the sensor has been
turned off. When the speed sensor is turned back on Teach new sensor? is displayed. Select NO. If YES is
selected, the monitor goes into teaching mode.
Teaching a New Cadence Sensor*
Select Settings > Bike > Bike1/2/3 > Cadence > On/Off. Teach new sensor? is displayed
• To teach a new sensor, make sure you are not near (40 m/131 ft) other Cadence sensors. Then
select Yes to confirm teaching. Start test drive is displayed. Rotate the wheel a few times to activate
the sensor. A flashing red light indicates that the sensor is activated. Completed!! is displayed once
the teaching process is over. The cycling computer is now ready to receive cadence data.
• Select No to cancel teaching. The cycling computer will not be able to measure cadence data.
Once the cadence sensor is taught to recognize the cycling computer, it will do so even if the sensor has
been turned off. When the cadence sensor is turned back on next time, Teach new sensor? is displayed.
Select NO and the monitor will go into On/Off mode. Select ON to activate the cadence sensor. If YES is
selected, the monitor goes into teaching mode.
Teaching a New Power Output Sensor*
Select Bike > Bike1/2/3 > Power > On/Off. Teach new sensor? is displayed.
• To teach a new sensor, make sure you are not near (40 m/131 ft) other Power Output sensors.
Then select Yes to confirm teaching. Start test drive is displayed. Rotate the wheel a few times to
activate the sensor. A flashing red light indicates that the sensor is activated. Completed!! is
displayed once the teaching process is over. The cycling computer is now ready to receive power
data.
• Select No to cancel teaching. The cycling computer will not be able to measure power data.
Once the power sensor is taught to recognize the cycling computer, it will do so even if the sensor has been
turned off. When the power sensor is turned back on, the Teach new sensor? is displayed. Select NO. The
monitor will go into On/Off mode. The power sensor last taught will be taken into use. If Yes is selected, the
cycling computer goes into teaching mode.
Teaching a New G3 GPS Sensor*
Turn the G3 GPS sensor on and then select Settings > Features > GPS > On in your cycling computer.
Teach new sensor? is displayed.
• Select Yes to confirm teaching. Completed! is dislayed.
• Select No to cancel teaching. The cycling computer will not be able to measure GPS data.
*Optional sensors required
12. BACKROUND INFORMATION
Polar Sport Zones
Polar sport zones offer a new level of effectiveness in heart rate-based training. Training is divided into
five sport zones based on percentages of your maximum heart rate. With sport zones, you can easily
Polar CS600X User Manual 47