Filter
Top Products
4 - 52 HOW TO USE THE INSTRUMENT
MEASURE CURSOR LIMIT
With cursor limited measurements it is possible to perform measurements on a
part of the waveform.
- Press the softkey next to CURSOR LIMIT& STATIST.
- Set CURSOR LIMITED to ’yes’.
- Turn the
∆
control to reduce the area between the cursors.
Notice that the measurement result shows dashes when the area between the
cursors gets too small.
- Press the RETURN softkey to return to the MEASURE menu.
- Turn off the measurements MEAS1 and MEAS2.
- Disconnect the probe from channel 2 before continuing to the next
section.