Filter
Top Products
6 - 12 THE CPL PROTOCOL
GO to REMOTE GR
Purpose:
Puts the oscilloscope in the Remote State. In the Remote State none of the
oscilloscope functions are accessible via the front panel buttons and knobs.
Going back to the Local State is achieved by sending the Go to Local (GL)
command or by pressing the STATUS/LOCAL key on the frontpanel (Refer also
to "Local Lockout" and "Go to Local").
Command:
Response:
Example:
100 PRINT #1,"GR" :’Send command
110 INPUT #1,ACK :’Sync on acknowledge
Local, Remote, Remote+Local Lockout States
"GR" CR
acknowledge CR
power-on
<STATUS/LOCAL button>
Remote State
Remote with
Local Lockout
State
Local State
"Go to Local"
"Reset Instrument"
"Go to Local"
"Reset Instrument"
"Go to Remote"
"Local Lockout"