Filter
Top Products
1190 Er Owner’s Manual
27
Workout Programs, continued
Entering Weight
1
. If ENTER key is pressed, the message window will flash once, “ENTER YOUR
W
EIGHT”, then “WEIGHT = XX” will start blinking.
2. Press “UP/DOWN” key to adjust the weight.
3. After weight is adjusted, then press “ENTER” key to accept.
Entering Program Time
1. If ENTER key is pressed, the message window will flash once, “ENTER
PROGRAM TIME”, then “TIME = 30 MIN” will start blinking.
2. Pressing “UP/DOWN” key to adjust the time. When the time setting reaches
60 minutes, the display will show “TIME = 1HR 00MIN”.
3. After time is adjusted, the message window will display “SET UP COMPLETED”
“PRESS ST
ART TO BEGIN”. You may press the “START” key to begin this
pr
ogram.
Note: You may press the START key at any time during program setup to skip the adjust-
ment and begin your workout. By doing so, the console will use default value of age and
weight for %HR and calories burned calculations.
During the Program
Display
• Once the program is started, the message window will display the workout data
of “Time, Intensity Level, Watts, and Calories”.
• Press the “SELECT” key to switch the display to “% Max HR, Strides/Min,
Distance, Strides”
• If no pulse is detected, the Pulse display will show “- - -” until there is a pulse,
and the HR bar graph will not be illuminated.
• If a pulse is detected, the Pulse display will display the BPM, and the HR bar
graph will illuminate to indicate your %Max. HR.
Adjusting Intensity Level
•
During the a Rest segment, press the level “UP” or “DOWN” key to adjust the
r
esistance up to 2 levels below the current Work setting or down to level 1. The
remaining Rest segments will be updated to the new setting in the dot matrix
profile as well.
• During the Work segment, press the level “UP” or “DOWN” key to adjust the
resistance down to 2 levels above the current rest setting and up to Level 20.
The remaining Work segments will be updated to the new setting in the dot
matrix profile as well.
Pause, Reset, Switch, Stop or Save the program
See Basic Operation section for details.
Ending the Pr
ogram
•
When the selected program time is up or the “STOP” key is pr
essed, there will
be a beep to signify the end of the program and Cool Down will become active
•
The message window will scr
oll the messages “THE PROGRAM ENDED” then
“3:00 COOL DOWN BEGIN”
• The “Start” key can be pressed to re-start the program.
• The “Stop” key can be pressed to skip the cool down mode and activate the
Workout Summary immediately.
119OM 8/28/06 11:43 AM Page 29