Filter
Top Products
27
BAS-761
9-3. Sewing with the folder in label attachment mode
¡ Two types of label attachment mode can be used: when DIP switch D-2 is set to OFF, alternate label attachment
is carried out, and when DIP switch D-2 is set to ON, continuous label attachment is carried out.
¡ With alternate label attachment, the folder switches alternately between label attachment mode and automatic
mode once for each sewing operation. During label attachment mode, the LABEL indicator e illuminates. If you
would like to switch over the modes, press the LABEL button e.
¡ With continuous label attachment, label attachment mode is active all the time. (The LABEL indicator e will re-
main illuminated.)
1. Set the folder mode to label attachment mode.
NOTE:
Refer to page 18 for details on how to set the folder mode.
2. Press the STACKER button r so that the STACKER indicator is illuminated.
3. Place the workpiece t under the gauge assembly q. (*1)
4. Depress the foot switch @3. The vacuum system will start operating to hold the workpiece t in place.
5. Place the pocket material y on top of the gauge assembly q.
6. Depress the foot switch @3, and hold it in that condition. The intermediate work clamp u will be set down on top of
the gauge assembly q and label setting will be possible.
Place the label i into the clamp o of the label attacher.
After setting the label i in place, release the foot switch @3. The clamp o of the label attacher will clamp the label
i and then rotate to the folding position.
If you would like to reclamp the label i, depress the foot switch @3 once more and keep it depressed. The label can
then be reset.
7. Press the RESTART buttones @4 simultaneously.
The pocket material y will be folded by the folder and the workpiece t and the pocket material y will then be
moved to the machine head and sewing will start. (*2)
8. Once sewing is finished, the stacker will operate and the workpiece w will be stacked. The machine head and the
work clamp will then return to the standby positions.
* If the LABEL indicator e is switched off, it means that automatic mode is active.
*1 If DIP switch D-1 has been set to ON, the gauge assembly q will retract. The gauge assembly q moves
forward at the same time the vacuum system starts operating when the foot switch @3 is depressed.
*2 If DIP switch A-1 has been set to ON, operation stops momentarily after folding has been completed so that
the folding can be checked. When the RESTART buttones @4 are pressed again simultaneously, operation
continues as before.
r
o
@3
@4
9. Sewing
i
t
u
q
y
e