Filter
Top Products
3
BAS-761
3. Installation
Machine installation should only be carried
out by a qualified technician.
Contact your Brother dealer or a qualified
electrician for any electrical work that may
need to be done.
The sewing machine head weights more than
400 kg. The installation should be carried out
by two or more people.
Co not connect the power cord until installa
tion is complete, otherwise the machine may
operate if the foot switch is depressed by
mistake, which could result in injury.
Be sure to connect the ground. If the ground
connection is not secure, you run the risk of
receiving a serious electric shock.
Do not place any objects on top of the top
cover, otherwise such objects may fall down
onto the machine.
If you need to put something on top of the top
cover, place it inside a box or similar to se-
cure it so as to stop it from falling down.
CAUTION
3. Installation
Be sure to wear protective goggles and
gloves when handling the lubricating oil and
grease, so that they do not get into your eyes
or onto your skin, otherwise inflammation can
result. Furthermore, do not drink the oil or eat
the grease under any circumstances, as they
can cause vomiting and diarrhoea.
Keep the oil out of the reach of children.
Avoid setting up the sewing machine near
sources of strong electrical noise such as
high-frequency welding equipment.
If this precaution is not taken, incorrect ma-
chine operation may result.
Hold the machine head with both hands when
tilting it back or returning it to its original po-
sition. Furthermore, after tilting back the ma-
chine head, do not push the face plate side
or the pulley side from above, as this could
cause the machine head to topple over, which
may result in personal injury or damage to
the machine.
Note:
¡ This sewing machine has a movable machine head and work clamp. Be careful not to place other objects within
the moving range of these parts.
¡ Supply power directly from a receptacle for the machine's exclusive use.
¡ Be sure to power off when installating.
3-1. Installation of the machine table
1. Secure the level adjusters q so that the table top re-
main level.
2. The table has eight level adjusters. If the table does not
sit well, loosen nuts w and turn the level adjusters q
to level the table.
Note:
There are eight adjusting points.
q
w
e
To move the machine, turn up adjusters q, and the table
can be moved on its machine body casters e.