Filter
Top Products
26
BAS-761
9. Sewing
9-2. Sewing with the folder in pattern matching mode
2. Press the FOLDER RESET button !9. The machine head will
move to the home position and then stop in the standby
condition.
3. Set the folder mode to pattern matching mode.
NOTE:
Refer to page 18 for details on how to set the folder mode.
4. Press the STACKER button r so that the STACKER indicator is illuminated.
5. Place the workpiece w under the gauge assembly q. (*1)
6. Depress the foot switch @3. The vacuum system will start operating to hold the workpiece w in place.
7. Place the pocket material e on top of the gauge assembly q.
8. When the foot switch @3 is released from being depressed, the gauge assembly q will drop to its lowest position.
If the pattern on the pocket material e is not aligned with the pattern on the workpiece w at this time, depress the
foot switch @3 once more. The vacuum system will turn off and the gauge assembly q will move one step upward
so that the patterns can be matched.
9. Press the RESTART buttones @4 simultaneously.
The pocket material e will be folded by the folder and the workpiece w and the pocket material e will then be
moved to the machine head and sewing will start. (*2)
10. Once sewing is finished, the stacker will operate and the workpiece w will be stacked. The machine head and the
work clamp will then return to the standby positions.
*1 If DIP switch D-1 has been set to ON, the gauge assembly q will retract. The gauge assembly q moves
forward at the same time the vacuum system starts operating when the foot switch @3 is depressed.
*2 If DIP switch A-1 has been set to ON, operation stops momentarily after folding has been completed so that
the folding can be checked. When the RESTART buttones @4 are pressed again simultaneously, operation
continues as before.
Press
FOLDER RESET SW
to start searching for home
position.
r
e
q
@3
@4
w
1. Turn on the air pressure and then turn on the power switch.
The following screen will be displayed on the panel.