Filter
Top Products
7
BAS-761
3-8. Installation of the folding group assembly
Before installation
¡ Apply air pressure.
¡ Turn on power switch q to return the machine to the home position.
¡ Turn valve switch w to OFF (lower) side and "E-820" will flash on the display.
1. Install folding clamp assembly e onto folding base r.
2. Attach multi-connector t.
3. While pushing the folding clamp assembly e downwards with your hand, install the inner clamp assembly y to
the folding base r. For models with a label attachment device u, install the plug i of the label attachment device
u to the socket o.
At this time, set the label attachment device u so that it is in a ready condition on top of the inner clamp assembly.
(Refer to page 27.) If it is reversed, it will turn downward.
4. Install center blade assembly !0 on folding base r.
5. Install sewing clamp assembly !1 on sewing clamp assembly arm base !2.
6. Install the multi-connector !4 and the dual sensor harness assembly !3.
7. Set the valve switch w to ON (up position).
The "E-820" indication will disappear from the display panel and the panel will return to its previous condition.
8. Move folding clamp assembly e, inner clamp assembly y, center blade assembly !0 and sewing clamp assembly
!1 back and forth, and right and left, to ensure they are secured.
o
i
t
w
r
!0
q
!1
!3
u
y
e
@1
!4
3. Installation
!2